Management of Fractures of the Long Bones of Eight Cats using External Skeletal Fixation and a Tied-in Intra-medullary Pin With a Resin-acrylic Bar
World Small Animal Veterinary Association World Congress Proceedings, 2007
A.J. Worth
Massey University Veterinary Teaching Hospital, Institute of Veterinary, Animal and Biomedical Sciences, Massey University
Palmerston North, New Zealand

Case History and Clinical Findings

Eight feline patients with fractures of the humerus, femur or tibia were presented non-weight-bearing with varying degrees of soft tissue and concurrent injury. Five fractures were comminuted, two were open fractures and there was one malunion. Fracture repair was performed in each case using a low-cost resin-acrylic (Selley's Steel Knead-it) external skeletal fixator (ESF). An open, limited open or "open but do not touch" approach allowed intramedullary (IM) pinning of the major fragments, establishing axial alignment and countering bending stress. Application of the Type-Ia ESF using small diameter half-pins provided stabilisation against rotational and compressive forces. The half-pins and tied-in IM pin were incorporated into a composite bar with the resin acrylic.

Diagnosis and Results

Seven cats, including all 5 comminuted fractures, had uncomplicated fracture healing. Median time to complete removal of the construct was 7 (range 5 to 12) weeks. In the eighth cat an open fracture developed into a non-union, which required revision with a plate and bone graft. This cat and six others available for follow-up (median 6 months) were reported by their owners to enjoy normal activity. Two had a mild, intermittent lameness, one had a mild but persistent lameness and four were sound. Six out of seven owners rated the appearance of their pet's limb as normal.

Clinical Relevance

The resin-acrylic ESF/tied-in IM pin construct was versatile and lightweight and allowed even highly comminuted non-load-sharing fracture configurations to be stabilised successfully using a biological strategy. Failure of the pin/acrylic interface did not occur and the frames provided sufficient strength as evidenced by healing without failure of the bar in these selected cases. A resin-acrylic ESF construct is inexpensive and affords the occasional orthopaedist the means to provide rotational stability when IM pinning has been used as the primary mode of fracture repair for short-oblique and transverse fractures. An extensive and costly clamp/bar inventory is not required, and there is greater flexibility for the orientation and placement of fixation pins than allowed by the traditional linear bar systems.

Speaker Information
(click the speaker's name to view other papers and abstracts submitted by this speaker)

Andrew Worth
Massey University Veterinary Teaching Hospital
New Zealand

MAIN : Abstracts - Poster : Management of Fractures
Powered By VIN

Friendly Reminder to Our Colleagues: Use of VIN content is limited to personal reference by VIN members. No portion of any VIN content may be copied or distributed without the expressed written permission of VIN.

Clinicians are reminded that you are ultimately responsible for the care of your patients. Any content that concerns treatment of your cases should be deemed recommendations by colleagues for you to consider in your case management decisions. Dosages should be confirmed prior to dispensing medications unfamiliar to you. To better understand the origins and logic behind these policies, and to discuss them with your colleagues, click here.

Images posted by VIN community members and displayed via VIN should not be considered of diagnostic quality and the ultimate interpretation of the images lies with the attending clinician. Suggestions, discussions and interpretation related to posted images are only that -- suggestions and recommendations which may be based upon less than diagnostic quality information.


777 W. Covell Blvd., Davis, CA 95616


  • Toll Free: 800-700-4636
  • From UK: 01-45-222-6154
  • From anywhere: (1)-530-756-4881
  • From Australia: 02-6145-2357